46
10. ASSEMBLY
ASSEMBLY ON THE WORKBENCH
There are holes (36) at the base of the saw
for easy installation on a workbench.
Attach the saw to a flat, level workbench or
worktable.
For this, insert the screws in the base of the
saw using the mounting holes (not included
in the scope of delivery).
NOTE:
If required, you can also attach the
saw to a piece of plywood with a minimum
thickness of 13 mm. The plywood can then
be fixed to the work surface by means
of clamps or transported to another
workstation and fixed there again.
CAUTION!
The mounting surface must
be level. An uneven surface may result in
jamming of the saw blade or an inaccurate
cut.
Mounting side support (Fig.4)
Insert the guide rod into the side supports
twice and then insert the guide rods into
the provided position holes (33) on the saw
table.
Assembly of a chip bag (Fig.5)
The chip bag (15) fits the connection of
the suction device (26). To ensure efficient
operation, empty the chip bag when it is
half-full.
Set the table at right angles to the saw
blade (Fig.6-Fig.7)
The power cord must be disconnected from
the power source.
Open the tilt angle lock (24) and set the saw
arm (5) to an angle of 0 ° by operating the
release button (6) (that is, the saw blade
is at an angle of 90 ° to the mitre table).
Tighten the tilt angle lock (24).
Set mitre angle (fig.8)
Fix the mitre table (20) in the 0 ° position.
Open the mitre lock (16) and tilt the
machine head all the way to the left / right
with the handle.
Adjust mitre angle lock.
Laser line
Operate the on / off switch (2) for the laser
light.
(Fig.21)
LED light
The device is delivered with an LED light.
The LED light (10) makes it possible to
illuminate the device in unfavourable
lighting conditions.
The LED light illuminates when you press
the on / off switch for LED light (4).
Set the cutting depth (fig.9)
Unlock the saw head lock (6) by pulling it
out. The saw head swings upwards.
Set the desired depth of cut with the
adjusting screw (29).
Secure the stopper bolt with the depth stop
adjustment screw (31).
.
Stop position and side supports
(fig.11-Fig.12)
The device is delivered with a pre-set stop
position:
Turn the adjusting screw for stop position
(B11 / Pos. 13) and move the stop to the
desired position B12.
Long pieces of wood can be supported with
UK
Summary of Contents for 210.200.356
Page 2: ...2 7 1 5 23 14 12 31 30 22 24 19 32 11 13 16 10 27 28 29 26 15 9 35 33 18 36 21 1 ...
Page 3: ...3 7 2 4 8 6 17 2 3 4 25 34 32 35 33 ...
Page 4: ...4 15 26 18 13 18 29 29 31 30 30 16 19 20 22 21 6 5 7 9 11 6 8 10 12 ...
Page 5: ...5 27 28 1 3 10 11 13 15 17 19 14 16 18 20 ...
