55
1. Remove the console back cover. Connect the Signal connected wire to
the
Antenna board (Figure A).
2. Remove the HR board and put the Antenna board on the front cover (Figure B).
3. Put the Foam Tap on
the
Antenna board (Figure C).
4. Install the HR board
on top of
the Antenna board (Figure D).
5. Connect the Signal connected wire to
the
UCB (Figure E).
6. Use the Tape f
to hold the
Signal connected wire (Figure F).
figURe D
figURe c
figURe b
figURe A
figURe f
figURe e
10.2 RfiD insTAllATion - conTinUeD
cHAPTeR 10: console sPecificATions AnD AsseMbly gUiDe
Summary of Contents for 7xe
Page 1: ...2 0 1 6 7 x e 7 x i c o n s o l e SE R V ICE M A N U A l...
Page 37: ...35 pad Chapter 8 Troubleshooting 8 1 electrical diagramS CONTINUED Digital Communication Wire...
Page 62: ...60 NOTES...
Page 63: ...61 MATrix Fitness systems corp 1610 Landmark Drive Cottage Grove wi 53527 USA REV 01 KO...
