45
8.17 link ArM rePlAceMent - continUed
cHAPter 8: PArt rePlAceMent gUide
figUre e
figUre f
figUre g
figUre H
4) The swing arm can now be separated from the pedal arm (Figure E).
5) Remove the 3 bolts that hold on the mounting plate at the link arm / pedal arm joint (Figure F).
6) Note the plastic washer that mounts at the end of the shaft, this will needed during re-assembly (Figure H).
7) Slide the pedal arm shaft out of the link arm housing noting the arrangement of the washers on the pedal arm shaft. (Figure I).
8) Reverse Steps 1-7 to install a new link arm.
9) Test the Ascent Trainer for function as outlined in Section 9.19.
Summary of Contents for A5x-02
