56
9.12 CONSOLE MAST HANDLEBAR REPLACEMENT
1) Turn off the power and disconnect the cord from the machine.
2) Remove the 4 bolts that hold the handlebar to the console mast (Figure A).
4) Pull the handlebar away from the console mast to expose the HR grip wiring (Figure B).
5) Carefully remove the wires from inside the console mast until the connectors on the ends come free and disconnect (Figure C).
6) To install a new handlebar assembly, connect the new handlebar and carefully push the heart rate wires into the console mast.
7) Attach the new handlebar assembly to the console mast using the 4 screws removed in Step 3.
8) Test the Ascent Trainer for function as outlined in Section 9.22.
FIGURE A
FIGURE B
FIGURE C
CHAPTER 9: PART REPLACEMENT GUIDE
Summary of Contents for A7X-04
