26
8.5 gEnErator bElt rEplacEMEnt
1) Turn off the power and disconnect the cord from the machine.
2) Remove the left side front disk from the machine as outlined in Section 8.1.
3) Remove the left side shroud from the machine as outlined in Section 8.2.
4) Remove the screw holding the Generator axle in place on the right side of the frame (Figure A).
5) Loosen the large nut on the tension eye bolt on both sides of the frame (Figure B).
6) Remove the tension eye bolt nut from the Generator bracket on both sides of the frame (Figure C).
7) Once the tension eye bolts have been removed, slide the Generator towards the back of the unit and off of the Generator bracket (Figure D), this
will allow you to remove the Generator belt from the Generator and pulley axle set (Figure E).
8) Reverse Steps 1-7 to install a new Generator belt. NOTE: Be sure to tighten the new Generator belt to 85 ft / lbs using the Generator eye bolts.
8) Test the Elliptical Trainer for function as outlined in Section 8.21. .
cHaptEr 8: part rEplacEMEnt gUidE
figUrE a
figUrE b
figUrE c
figUrE d
figUrE E
Summary of Contents for E3X-01
