28
8.7 pUllEy axlE SEt rEplacEMEnt
1) Turn off the power and disconnect the cord from the machine.
2) Remove both front disks from the machine as outlined in Section 8.1.
3) Remove both front shrouds from the machine as outlined in Section 8.2.
4) Remove the Generator belt as outlined in Section 8.5.
5) Remove the drive belt as outlined in Section 8.6.
6) Remove the 75 mm nut holding the pulley axle in place using the large socket available from Matrix (Figure A).
7) Use a hammer or mallet to remove the pulley axle from the left side (Figure B) and clean any debris from the frame (Figure C).
8) Reverse Steps 1-7 to install a new pulley axle set, making sure to tighten the 75mm nut to 100 N-m torque. Re-tension the belts as outlined in
Sections 8.5 and 8.6.
8) Test the Elliptical Trainer for function as outlined in Section 8.21.
figUrE a
figUrE b
figUrE c
cHaptEr 8: part rEplacEMEnt gUidE
Summary of Contents for E3X-01
