45
8.20 rollEr track rEplacEMEnt
1) Remove the 3 bolts that hold on the mounting plate at the crank arm / pedal arm joint (Figure A). Note the plastic washer that mounts at the end
of the shaft (Figure B).
2) Slide the pedal arm shaft out of the crank arm housing (Figure C) noting the order of the washers on the pedal arm shaft (Figure D).
3) Remove the 2 screws on each side holding on the rear end cap and remove it (Figure E & F).
4) Remove the middle plastic cover from between the pedals by pulling it towards the rear of the unit (Figure G).
5) Remove the 3 screws holding the top roller track in place (Figure H).
6) Move the crank arm to the side off of the roller track.
7) Remove the 3 screws holding the bottom roller track to the frame (Figure I) and remove the roller track (Figure J).
8) Reverse Steps 1-7 to install a new roller.
9) Test the Elliptical Trainer for function as outlined in Section 8.21.
figUrE a
figUrE b
figUrE c
figUrE d
cHaptEr 8: part rEplacEMEnt gUidE
Summary of Contents for E3X-01
