59
9.21 tESting tHE SuSpEnSion Elliptical
oncE tHE unit oR REplacEMEnt paRt iS fully inStallEd and aSSEMblEd and
pRopERly placEd on tHE flooR, uSE tHE following inStRuctionS to tESt
tHE MacHinE:
1) Enter Engineering Mode and input the serial number of the console. Also set the Machine Type and verify that the Date and Time are
correct.
2) If the unit has an add on TV, perform a channel scan to tune the TV (see the TV Owner's Manual for procedure).
3) Without hitting start or entering any exercise modes, stand on the machine and hold the handlebars while initiating movement to simulate
exercising. While moving listen for any odd noises or squeaks.
4) After stopping movement, press the green GO key and begin using the machine.
5) Grasp the hand grips to check for proper heart rate response.
6) Press the LEVEL UP and DOWN keys both on the hand grips and on the console to make sure resistance is fully functional.
7) If everything functions properly, stop pedaling and the unit will reset to normal operation after 30 seconds.
cHaptER 9: paRt REplacEMEnt guidE
Summary of Contents for E5X-04
