40
9.3 lowEr control board rEplacEMEnt
1) Turn off the power and disconnect the cord from the machine.
2) Remove the right side front disk from the machine as outlined in Section 8.1.
3) Remove the right side front shroud as outlined in Section 8.2.
4) Disconnect all wires from the LCB (Figure A).
5) Remove the 2 screws holding the LCB to the frame and remove the LCB. (Figure B).
6) Reverse Steps 1-5 to install a new LCB.
7) Test the Elliptical Trainer for function as outlined in Section 8.21.
figUrE a
figUrE b
cHaptEr 9: part rEplacEMEnt gUidE
