Matrix MIN600SI, Manual For Installation, Use And Maintenance

7

  2. Remove the filter retaining wires from the cover panel.

  3.  Remove the grease filter and wash by hand in a lukewarm 

solution of water and mild detergent.  Once clean squeeze 

the grease filter but DO NOT wring it out.  Clean the filter holder 

using a dilute solution of water and mild detergent or with a 

damp cloth.  Allow the grease filter to dry completely before 

reassembling the extractor.

  4. Replace the grease filter in the cover panel and reattach the  

      filter retaining wires.

  5.  Replace the cover panel by inserting the lugs on the upper side 

in the extractor, and then refasten the fixing clips on the lower 

side.

Aluminium grease filters:

  1.  Remove the filters from the cooker hood and wash in a solution of 

warm water and neutral liquid detergent, leaving to soak.

  2. Rinse thoroughly with warm water and leave to dry.

  3.  The filters may alternatively be washed in the dishwasher.  The 

aluminium panels may alter in colour after several washes in a 

dishwasher.  This is not a fault and is not cause for replacing the 

panels.

Changing the (circular) charcoal filter (re-circulating only):

To ensure best performance of your extractor, you should replace the 

charcoal filters every four to six months,

depending on use. 

ks into position.

  3. Replace the cover panel or grease filter that has been removed.