10
1.3 Before getting Started
This Treadmill is intended for commercial use. To ensure your safety and protect the equipment,
read all instructions before operating the MATRIX treadmill.
When using an electrical product, basic precautions should always be followed including the
following:
DANGER:
To reduce the risk of electric shock: Always unplug this equipment from the
electrical outlet immediately after using and before cleaning.
WARNING :
To reduce the risk of burns, fire, electrical shock or injury to persons that may be
associated with using this product.
•An appliance should never be left unattended when plugged in. Unplug from outlet when not in
use and before putting on or taking off parts.
•This product must be used for its intended purpose described in this lower case owner’s manual.
Do not use other attachments that are not recommend by the manufacturer. Attachments may cause
injury.
•To prevent electrical shock, never drop or insert any object into any opening
•Do not remove the console covers. Service should only be done by an authorized service
technician.
•Never operate the treadmill with the air opening blocked. Keep the air opening clean, free of lint
and hair.
•Never operate product if it has a damaged cord or plug, if it is working properly, if it has been
damaged, or immersed in water. Return the unit to a service center for examination and repair.
•Do not carry this unit by it’s supply cord or use the cord as a handle.
•Keep any power cord away from heated surfaces.
•Close supervision is necessary when treadmill is used by or near children or disable persons.
•Do not use outdoors
•Do not operate where aerosol (spray) products are being used or when oxygen is being
administered.
•To disconnect, turn all controls to the off position, then remove plug from outlet.
•Connect this treadmill to a properly grounded outlet only.
Caution:
If you experience chest pain, nausea, dizziness or shortness or breath, STOP exercising
immediately and consult a physician before continuing.
Summary of Contents for MX-T3x
