20
machine is connected is earthed in compliance
with current safety regulations and that the
current socket is in perfect condition.
The electrical system must be fitted with a
magnetothermal protective device to safeguard
all conductors from short circuits and overload.
The selection of this device should be in line
with the following electrical specifications of the
machine stated on the motor.
NOTE: Your plunge cut saw’s electrical system
is equipped with an undervoltage relay which
automatically opens the circuit when the voltage
falls below a minimum pre-established
limit and which prevents the self-reset of
machine functions when voltage returns to
normal levels.
If the machine stops involutarily, do not be
allarmed.
Make sure that there has not been a voltage
failure in the electrical system.
ADJUSTING
Caution: Prior to carrying out one of the following
adjustment steps, switch the machine off and
unplug the mains plug.
Cutting depth adjustment, Fig. 2
The cutting depth can be adjusted from 0 to 45
mm.
Unfasten the cutting depth adjustment screw
(6) and set the required depth using the scale (7)
and retighten the screw.
The dimentions on the rail shows the cutting
depth without rail.
Mitre settings, Fig. 3
The mitre square can be set from 0° to 45°.
Unfasten the mitre adjustment screws (8) on both
sides, set the desired mitre square on the scale (9)
and retighten both screws.
Saw blade replacement, Fig. 4, 5, 6
Caution: Before you are going to make the
saw blade change, switch off the machine and
unplug the power cord.
1 Press the plunge trigger (3), bring the saw blade
into the blade-change position (Adjustment
screw for depth of cut shall be adjusted to 25mm)
and insert the hex wrench into the blade locking
screw (17).
2 Press on the shaft lock (13) and rotate the saw
blade (10) until the lock clicks into place.
3 Hold down the locking shaft (13) and open
the blade locking screw (17) counter clockwise,
while keeping the blade in the blade-changing
position.
4 Remove the outer flange (16) and the saw blade
(10).
(Caution: risk of injuries, wear protective
gloves)
5 Insert the new blade and flange.
6 Screw in and tighten the saw blade locking
screw while keeping the shaft locking mechanism
pressed again.
7 Set the plunge saw to its original position.
Operations
After having performed all the above procedures
and operations, you may begin cutting.
ATTENTION: Always keep hands away from the
cutting area and do not try to approach it when
the machine is running.
Switching the product on/off, Fig. 1
To switch the plunge-cut saw on, press the on/off
switch (4). To switch off, release the on/off switch
(4).
Operating and holding the plunge-cut saw,
Fig. 8
1 Secure the work piece so that it cannot get
displaced or moved while sawing.
2 Only move the saw forwards.
3 Grip the saw tightly with both hands ensuring
Summary of Contents for PS 1000-45
Page 2: ...2...
