22
Make sure the cable is disconnected from the
mains when checking.
Electrical connection cables must comply with
the regulations applicable in your country.
Single-phase motor
• The mains voltage must coincide with the
voltage specified
on the motor’s rating plate.
• Extension cables up to a length of 25 m must
have a cross-section of 1.5 mm
2
, and beyond 25
m at least 2.5 mm
2
.
• The connection to the mains must be protected
with a 16 A slow-acting fuse.
Only a qualified electrician is permitted to
connect the machine and complete repairs on its
electrical equipment.
In the event of enquiries please specify the
following data:
• Motor manufacturer
• Type of current of the motor
• Data recorded on the machine’s rating plate
• Data recorded on the switch’s rating plate
If a motor has to be returned, it must always be
dispatched with the complete driving unit and
switch.
Accessories
Rail: 800 / 1400 mm
Maintenance
If specialist personnel must be brought in
for extraordinary service or repairs during
the warranty period and thereafter, please
contact a service provider recommended by
us or contact the manufacturer directly.
• Overhauls, maintenance work, cleaning, as well
as the elimination of any malfunctions must only
be undertaken after turning off the motor.
• All protective and safety equipment must be
reinstalled immediately upon completion of any
repair or maintenance work.
REGULAR MAINTENANCE
The regular maintenance decribed above and
in the paragraph below can be carried out by
unskilled personnel.
• Do not oil the plunge cut saw, cause cutting
must be carried out in dry conditions; all rotating
parts are self-lubricating.
• During maintenance, wear protective gear
if possible (accident-prevention goggles and
gloves).
• Remove cuttings when necessary both from the
cutting area, work surfaces and support bases.
Use of an aspirator or brush is recommended.
ATTENTION: Do not use compressed air jets!
• Regularly check blade conditions: if difficulties
should arise during cutting, have it sharpened by
skilled personnel or replace it if necessary.
ASSISTENCE
When in need of skilled personnel for special
maintenance, or for repairs, both during and
following the guarantee period, always apply to
authorized centres for assistance or directly to
the manufacturer if there is no authorized centre
in your area.
DISPOSAL OF THE MACHINE.
Once its operating activity is finished, the
disposal of the machine must take place through
a normal collection and disposal Center for
industrial waste.
Summary of Contents for PS 1000-45
Page 2: ...2...
