●
The remote control function may be out of work if there is a
barrier between the remote control and heater .
●
Replacing the batteries duly so as not to affect the normal use of
heater and remote control.
Operation Instruction
●
Remove all package material (including anti-vibration object of the lamp) and
check the appliance, supply cord and the plug for signs of damage.
●
Pay attention to the mounting place and all mounting material(dowels, screws).
Ensure they are suitable and stable enough for mounting and lastingly holding
of the appliance.
●
Before mounting, the minimum safe mounting distances and tilt angles shown
in the figures must be strictly followed.
●
The distance between the bottom edge of the appliance and the floor must be
at least 1.8 M. See figure 2.
●
There must be a distance of at least 0.25 M between the appliance and the
ceilings, roofs or other covers. See figure 2.
●
There must be a distance of at least 0.5 M at each side between the appliance
and walls or the like. See figure 2.
●
Recommended degree to mounting surface is 45°. See figure 3.
●
Pay attention that, the installation of the appliance must not add excessive
wind load. (can not use fan to blow the heater or add spare part inside the
heater)
●
Fix the mounting bracket to the ceiling l first. Ensure that the place to be
installed is secure and firm. Or connect the appliance to the stand.
●
Adjust the desired angle of radiation and fest screw all screws. Check regularly
the screw's connection. Mechanical bearing pressure and oscillation due to
wind or rain could lead to loose.
●
Plug in the power source and operate the remote control. Then observe,
whether during the first 10-15 minutes the appliance works trouble-free.
●
If you do not use,please remove batteries from the socket of remote control.
Figure1: Mounting bracket and anchor
dowels provided. Connection from the wall
to the infrared heater.
Figure2: Min. distance to floor, ceiling and
wall.
Figure3: Tilt angle.
Figure 4: Max.remote distance
