Matrix SETU VFXTH System Manual
96
•
For each calling party number, enter a corresponding destination number in the
Destination Number
column. Destination numbers may consist of a maximum of 24 characters. Digits 0 to 9, *, # and
.
(dot)
are allowed. Default: Blank.
•
Click
Submit
to save your entries. Close the window to return to the SIP Trunk page.
You can also configure the Calling Number Based Table from Advanced Settings. See
under Advanced Settings for instructions.
•
Select a method for routing incoming calls with CLI that
do not
match
with any entries in the Calling Party
Number Based Table.
In the
If no match found in the Calling Party Number Table, route calls
box, click the desired method
from the following options for processing the call:
•
to a Fixed Destination Number
•
to the Called Party Number
•
on the basis of DDI Number
Default: to the Called Party Number.
Route on the basis of DDI Number
In this method, a call received on the SIP Trunk is routed to a specific number as per the DDI number received in
the SIP INVITE message.
You must configure the DDI numbers in the DDI Number Based Table. When there is an incoming call on the SIP
Trunk, SETU VFXTH will match the CLI of the number received with the entries of this table. If a match is found for
the number in the table, the call is routed to the destination port.
To apply this method, do the following:
•
In the
Route all Incoming calls with CLI
list, click
on the Basis of DDI Number
.
•
Click
Settings
.
