89
Matrix SETU VFXTH System Manual
You must configure the Trusted IP Address Table
to receive incoming calls on this SIP Trunk. If you
do not configure this table, incoming calls on this SIP Trunk will be rejected. You can configure
maximum 10 entries in the Trusted IP Address table. To do so, click Settings
.
The
Trusted IP Address Table
opens in a new window.
•
Enter the
IP Address
and the corresponding
Port
from which you want to allow incoming calls
on this SIP Trunk. You can configure maximum 21 characters. Allowed characters are
0-9
,
dot
(
.
),
colon
(
:
).
Do not configure the port, if you want to allow incoming calls from all the ports for a particular IP
Address.
•
Click
Submit
and close the window.
•
As per Peer-to-Peer table:
If you select this option, the system matches the IP Address: Port
received in the INVITE message (Source IP address from the Network layer and Source Port from
the Transport layer) with the Destination Address configured in the Peer to Peer table. If a match is
found, then the call will be routed to the desired destination. Else the call will be rejected.
•
Any:
If you select this option,
Digest Authentication
will be enabled automatically. The system will
allow incoming calls only after the callers authenticates themselves with the correct credentials—
User ID and Password. The system matches the User ID and Password entered by the callers with
the entries stored in the Digest Authentication table. If a match is found, the call will be routed to the
desired destination. Else the call will be rejected.
Default:
As per Peer to Peer table
.
•
If you set
Allowed IP Address for Incoming SIP Message
to
As per Trusted IP Address table
or
As per
Peer to Peer table
, you may also enable the
Digest Authentication
. Incoming calls on this SIP Trunk
will be allowed only after the callers authenticate themselves with their User ID and Password. Default:
Disabled.
