Safety instructions
Due to their design and construction, MATRIX
machines comply with the relevant essential
health and safety requirements of the EC
directives; they therefore have the CE sign.
Safety Instructions
The machine may only be used by persons who
are adequately trained for the use of the machine
or who have provided proof of their skills
regarding the use of the machine and who are
explicitly commissioned to use the machine.
The machine must not be used by people with
reduced physical, sensory or mental capacities,
including children or people who lack experience
or knowledge.
Children must be supervised to ensure that they do not
play with the machine.
Do not use the machine in rooms where explosive
or highly combustible substances (e.g. gas,
solvents, heating fuel, dust, etc.) are stored or
processed.
These substances could be ignited by the electrical or
mechanical components of the machine.
Pay attention to the local situation as well as to
third persons and children! In the vicinity of blind
spots such as doors or curves in particular, it is
important to reduce speed.
Do not transport other persons and objects with
this machine.
In case of malfunction or defect or after collisions
or toppling over, the machine must be inspected
by an authorized expert before restarting. The
same applies if the machine was left outdoors,
immersed in water or subjected to moisture.
The machine must be stopped immediately in the
event of damage to safety-relevant parts such as
power supply cords, or covers that enable access
to live parts.
The machine must not be stopped, parked or
stored on slopes.
The machine must be switched off for any work
carried out on the machine.
The machine must not be used on slopes >2%.
Sharp cornering on slopes can affect the stability
of the machine and is therefore prohibited.
Danger of accident.
The machine may only be used on a fixed, stable
and sufficiently load-bearing surface.
In the case of non-adherence there is a risk of
accidents.
Operate and keep the machine in a dry and low-
dust environment at temperatures between
+10°C / + 50°F and +35°C/ + 95 °F degrees only.
Only authorized experts who are familiar with all
safety instructions relevant for this machine are
allowed to repair mechanical or electrical machine
parts.
Only tools (brushes, nozzles or similar) that are
specified in these instructions of use under
accessories, or which have been recommended
by a MATRIX consultant, may be used. Any other
brushes might impair the safety and functions of
the machine.
National regulations for personal protection and
accident prevention as well as the manufacturer's
instructions for the use of cleaning solutions must
be consistently observed.
In case of water leakage from the machine, the
unit must be switched off immediately.
The machine must be protected against
unauthorized use. Therefore, keep the machine in
a locked room before leaving it.
Further Information
The electric diagram of this machine is
provided in the spare parts list.
- Please contact your customer service for further
information.
These instructions of use as well as all
instructions of use for MATRIX machines are
available on the following website:
www.matrixcleaningsystems.co.uk
Danger
Danger
Warning
Warning
Warning
Warning
Danger
Danger
Danger
Danger
Danger
Danger
Danger
Danger
Danger
Caution
Notice
Notice
Notice
EN
39
Summary of Contents for SO8
Page 129: ...129 ...
