56
9.16 SPeed or iNCliNe keyPAd rePlACemeNT
1) Turn off power to the treadmill and remove the power cord.
2) Remove the console as outlined in Section 9.12.
3) Remove the console frame as outlined in Section 9.14.
4) Remove the 2 screws holding the emergency stop frame to the console frame (Figure A).
5) Lay the console frame on its face and remove the 7 screws holding the back panel to the console frame and lean the console back out of the
way (Figure B).
6) Disconnect the ribbon cable of the affected keypad (Figures C & D).
7) Peel the keypad up from the front side of the console and remove it.
8) Reverse Steps 1-7 to install a new keypad.
9) Test the treadmill for function as outlined in Section 9.21.
fiGUre A
fiGUre b
fiGUre C
fiGUre d
CHAPTer 9: PArT rePlACemeNT GUide
