6
CHaPTer 3: PreVeNTaTiVe maiNTeNaNCe
3.3 Care aNd maiNTeNaNCe iNSTrUCTioNS
In order to maximize life span, and minimize down time, all
Matrix Fitness System's equipment requires regular cleaning, and
maintenance items performed on a scheduled basis. This section
contains detailed instructions on how to perform these items and
the frequency of which they should be done. Some basic tools and
supplies will be necessary to perform these tasks which include (but
may not be limited to):
* Metric Allen wrenches
* #2 Phillips head screwdriver
* Adjustable wrench
* Torque wrench (capability to read foot lbs and inch lbs)
* Lint free cleaning cloths
* Teflon based spray lubricant such as "Super Lube" or other Matrix
approved products.
* Mild water soluable detergent such as "Simple Green" or other
Matrix approved products
*Vacuumcleanerwithanextendablehoseandcrevassetool
attachment.
You may periodically see addendums to this document, as the
Matrix Technical Support Team identifies items that require specific
attention, the latest version will always be available on the Matrix
web site at www.matrixfitness.com.
daily maiNTeNaNCe iTemS
1) Clean the entire machine using water and mild detergent such as
"Simple Green", or other Matrix approved solutions (cleaning agents
MUST be alcohol and ammonia free).
2) Check the emergency stop button and cord for proper operation.
moNTHly maiNTeNaNCe iTemS
1) Inspect the power cord for damage, inspect the hand grip
areas, and inspect the emergency stop button and cord for proper
operation.
2) Check the running belt for proper tension, adjust as needed.
qUarTerly maiNTeNaNCe iTemS
1) Remove the front plastic cover, and vacuum the entire inside
area of machine. Be careful when working around the MCB not to
bump any wires or connections loose.
2) Check the drive belt for visible wear, ie, cracking, tears, etc. The
belt should be replaced if there are any visible signs of damage.
Proper alignment of the pulley / tensioner should be verified at this
time as well.
3) Remove the plastic shroud at the front of the machine. Start
the unit and raise the incline settings to maximum height. Turn
the power switch off at the front of the machine to prevent it from
lowering accidentally. Lubricate the incline motor Acme screw
(Matrix recommends Super Lube brand grease with PTFE additive).
bi-aNNUal maiNTeNaNCe iTemS
1) Remove any wax build up from the front and rear rollers of the
machine.
2) Inspect the underside of the running belt for damage, check for
cracking or glazed surfaces.
3) If the belt has damage or wear to it that warrants replacement,
note that a new running belt should ALWAYS be installed on a new
deck surface (deck should either be flipped or replaced to gain a
new surface).
4) During normal operating conditions, the running belt
replacement and deck service should be done every 15,000 miles.
