48
9.12 LOWER CONTROL BOARD REPLACEMENT
1) Remove the shrouds as outlined in Section 9.11.
2) Remove the 3 screws holding the cover onto the lower board and remove the cover.
3) Disconnect the 5 wire connections to the lower board (Figure A).
4) Remove the 2 screws holding the lower board to the frame (Figure B), and remove the lower board.
5) Reverse Steps 1-4 to install a new lower board. Figure C shows the connections at the board.
6) Test the bike for function as outlined in Section 9.21.
FIGURE A
FIGURE B
FIGURE C
3 Pin Connector from
the Generator
2 Pin Connector
from the Resistor
8 Pin Connector
from the Console
2 Pin Connector from
the AC power source
2 Pin Connector
from the Battery
CHAPTER 9: PART REPLACEMENT GUIDE
