48
9.5 CoNSole KeyPAD / oVeRlAy RePlACeMeNT - CoNTINUeD
fIgURe e
fIgURe f
fIgURe g
fIgURe H
8) Press down on the corners of the overlay / keypad to keep it in place. Then remove the protective film (Figure G).
9) Once the overlay / keypad is in the correct position, press down on it to adhere it in positions (Figure H).
10) Use the same procedure to replace any additional faulty overlays / keypads.
note:
Overlays / keypads cannot be re-used.
11) Test the bike for function as outlined in Section 9.21.
6) Push the overlay / keypad ribbon cable through the hole in the console and plug it in (Figure E).
7) Match the overlay / keypad to the cutout in the console (Figure F).
CHAPTeR 9: PART RePlACeMeNT gUIDe
Summary of Contents for U7xe-04
