74
10.6 TV PRogRAMMINg INSTRUCTIoNS
CHAPTeR 10: BIKe SPeCIfICATIoNS AND ASSeMBly gUIDe
Once the cardio equipment has been installed, and proper power and cable wiring is provided, The Television must be programmed to the club's
channels and settings.
auto scan
- An auto scan will search for channel signals from the coax cable. It will tune in all channels that provide a signal.
1. Press ENTER, 1, 0, 0, 1, ENTER on the number keypad to enter Manager Mode.
2. Press TV on the display (Figure A).
3. Press SETUP on the display (Figure B). A TV will appear.
4. Press the - key on the number keypad and a Menu will appear on the TV (Figure C).
note:
Once the Menu is present on the screen, the
following buttons must be pressed quickly, or the Menu will minimize after 5 seconds of no key strokes.
5.
Use the CHANNEL UP and DOWN keys to move, ENTER key to enter this action in the Menu.
Use the VOLUME UP and DOWN keys to
select item and
ENTER key to start / change / save this setting item
in the
sub-menu
.
6. Use the CHANNEL UP and DOWN keys to scroll the cursor to Installation of the Menu, then press the ENTER key to enter the Installation
sub-menu(Figure D).
7. Use the CHANNEL UP or DOWN keys to scroll down to Auto Scan (Figure E),
then press the ENTER key to s
tart the channel scan (Figure
F).
fIgURe B
fIgURe A
fIgURe f
fIgURe e
fIgURe C
fIgURe D
Summary of Contents for U7xe-04
