- 7 -
3.0 LOXX
™
H
ˎˊˍ˛ˎ˜˝
H
ˊ˛ˍˠˊ˛ˎ
I
˗˜˝ˊ˕˕ˊ˝˒˘˗
MOUNTING CLAMP INSTALLATION
(see
Fig 2
)
:
Secure the mounting clamp assembly (
E
) onto back shell
*
using hardware provided. If additional
clearance is required, install the spacer plate and long screws (
c
) provided.
(
*note:
the mounting clamp
hardware is installed from the inside of the back shell)
LOXX
™
HARDWARE INSTALLATION
(see
Fig 3
)
:
•
Loosen set-screw (
d
) and remove the lower D-Ring (
D2
) from the headrest post (
1
).
•
Install the headrest post (
F
) into the mounting clamp assembly (
E
), and adjust the headrest post
to the desired height/position (
2
).
(
note
: loosen upper D-Ring if necessary)
•
Tighten the mounting clamp (
E
) to secure the headrest post in position (
3
).
•
Adjust the upper D-Ring (
D1
) so that it rests flush with the top of the mounting clamp (
4
), then secure
the D-Ring into place via the set-screw (
d
).
•
Reinstall and secure the Lower D-Ring (
D2
) onto the headrest post (
5
) so that it rests flush with the
bottom of the mounting clamp assembly.
HEADREST POST MODIFICATIONS:
If necessary, the headrest post (
F
) can be cut (shortened) to prevent any collision interference along
the back of the wheelchair/seating system.
(
Note:
After cutting the post, the plastic end cap
(
G
)
can
be removed and re-installed into the newly cut post).
HEADREST PAD ADJUSTMENT
(see
Fig 4
)
:
Loosen the locking lever (
A1
) or locking screw (
A2
) on the upper pivot assembly (
B
). Slide the
horizontal bar (
C
) to the desired depth inside the upper pivot (
1
), and adjust the headrest angle by
pivoting/rotating the upper pivot to achieve the desired headrest position (
2
).
Re-tigthen the locking
lever/locking screw (
B
) to secure the headrest into position.
ELAN HEADREST PAD*
INSTALLATION
(see
Fig 5
)
:
Position the headrest mounting collar over the pivot ball on the horizontal bar (
1
); then align and
secure the mounting collar to the headrest pad (
2
).
*Note:
Headrest pad/mounting hardware sold separately
.
OPTIONAL LOCKING SCREW
(see
Fig 1
)
:
The locking lever (
A1
) may be replaced with the
optional 30
mm
locking screw (
A2
) provided. Unscrew the lever from the upper clamp housing and
retain the original washer (
a
). Being careful to keep the clamping block (
b
) in position inside the upper
pivot, use the 5
mm
hex key (provided) to install the replacement locking screw (with washer)
3.1 LOXX
™
I
ඖඛගඉඔඔඉගඑඖ
/S
ඍග
-
ඝ
I
ඖඛගකඝඋගඑඖඛ
WARNING!
Risk of injury
• Inspect the headrest hardware to ensure that there are no missing or damaged parts.
WARNING!
Risk of injury
• Before drilling or modifying any back shell, always contact the back manufacturer to ensure
the back is recommended for a headrest application.
(Refer to images provided in
Section
1.0 - ASSEMBLY OVERVIEW
(p.4-5))
