2: Mainboard Installation
11
Install Memory
This mainboard accommodates three184-pin 2.5V unbuffered
Double Data Rate (DDR) SDRAM DIMM sockets. You must
install at least one memory module in order to work out the
mainboard.
When you install DDR200/DDR266 memory modules, the
memory bus can run up to 100/133 MHz.
The DDR SDRAM DIMMs can synchronously work with 100
MHz or operates over a 133 MHz system bus.
You must install at least one memory module in order to use the
mainboard. Each module can be installed with up to 1.5GB
memory capacity
Installation Procedure
To install a module, please follow these steps:
1.
Push down the latches on each side of the DIMM socket.
2.
Align the memory module with the socket. The DIMM
sockets are keyed with notches and the DIMMs are keyed
with cutouts so that they can only be installed correctly.
3.
Check the cutouts on the DIMM module edge connector
matching the notches in the DIMM socket.
4.
Install the DIMM module into the socket and press it firmly
down until it is seated correctly. The socket latches are
levered upwards and lock the edges of the DIMM.
5.
Install any remaining DIMM modules.
DDR1
DDR2
DDR3
Summary of Contents for MS8328E Series
Page 4: ...Mainboard User s Manual IV ...
Page 24: ...Mainboard User s Manual 20 ...
