GB-23
INSTRUC
TION
M
ANU
AL
SECTION 8: AUTOMATIC FAILURE DETECTION SYSTEM
Your machine is equipped with systems which will both take the necessary precautions and
warn you in case of any failure by controlling itself constantly during the washing processes.
FAILURE CODE FAILURE
INDICATOR
PROBABLE
FAILURE
THE PROCESS TO BE DONE
Err 01
The start/pause
light blinks.
The door is not
shut properly.
Shut the door properly so that
you should hear a click. If the
problem persists, turn off the
machine unplug and contact an
authorised technician.
Err 02
The programme
ready light blinks.
The water level
in your machine
may be low. The
pressure of your
water supply
may be low or
blocked.
Check that the water supply to
the machine is unobstructed,
check the water tap is fully on.
If the the problem continues,
turn off the machine and contact
an authorised technician.
Err 03
The start/
pause light and
programme ready
light blinks .
The pump has
failed or the
pump filter is
obstructed.
Clean the pump filter. If the
problem persists, contact an
authorised technician. (*)
Err 05
The start/
pause light and
programme end
light blink.
The heater of your
machine or the
heat sensor has
failed.
Shut down your machine and
unplug. Turn off your tap and
contact an authorised technician.
Err 06
The programme
ready light and
programme end
light blink.
The motor has
failed.
Shut down your machine and
unplug. Turn off the tap and
contact an authorised technician.
Err 07
The programme
start/pause light,
ready light and
programme end
light stays on
permanently.
Configuration
error.
Shut down your machine and
unplug. Turn off the tap and
contact an authorised technician.
Err 08
The start/pause
light, programme
ready light and
programme end
light blink.
The motor has
failed.
Shut down your machine and
unplug. Turn off the tap and
contact an authorised technician.
Err 09
The programme
ready light and
programme end
light stays on
permanently.
The network
voltage is too
high or too low.
If the network voltage is lower
than 150V or higher than 260V,
your machine will automatically
stop. When the network voltage
is recovered, your machine will
continue its operation.
(*) See the section regarding the maintenance and cleaning of your machine.
M100WM10E_20100209_without PN.indd 23
