8
Fit the flexible ducting into the Ducting
socket adaptor.
Fit the unit into position. Tighten the
screws if necessary. Feed the flexible
ducting through the hole in the wall.
9
Fit the external grille.
10 The Charcoal filter is designed to remove
‘odours’ from dirty air. As the ‘odours’ are
being extracted to the outside air it is not
necessary to fit the Charcoal filter.
11 Fit the main filter panel by locating the
rear pins in their slots and pressing the
release buttons. It will click into place.
12 Connect the Cooker Hood to the power
supply, as mentioned earlier in the guide.
Ducted air installation
1
The Cooker Hood must be fitted so that it
protrudes 160mm from the cupboard it is
being fitted to (see page 2). This is to
allow the re-circulated air to escape
through the grille in the top of the unit.
2 Use the card template supplied to mark
the position of the fixing screws.
The keyhole slots are designed so the
Cooker Hood locates over the larger area of
the hole and is then pushed back, onto the
smaller area of the hole. Two extra ‘security
screws’ are used to ensure the unit is secure and
isn’t accidentally pushed off the keyhole slots.
Screw the keyhole positioned screws into your
wall or kitchen cupboard so that the top
surface of the screw head is approximately
4mm from the surface you are screwing to.
If you are top mounting the unit, drill all eight
holes, but don’t fit the four ‘security screws’
until the unit is in place.
3 Check that your fixings are correctly
located, by temporarily fitting the
Cooker Hood. If correct, remove the
protective film from each side of the unit.
4 Fit the unit into position. Tighten the
screws if necessary.
5 Fit the Charcoal filter (not supplied –
please contact the store from which you
purchased your Cooker Hood) by first
lift the filter up into the Cooker Hood,
aligning the posts with the locating holes
on the filter. Turn the filter clockwise
to lock it into position.
6 Fit the main filter panel by locating the
rear pins in their slots and pressing the
release buttons. It will click into place.
7
Connect the Cooker Hood to the power
supply, as mentioned earlier in the guide.
Re-circulated air installation
6
