GB
10
Operating Instructions
Switching On Your Freezer
1. Before connecting the freezer to the mains supply make
sure that the thermostat control dial is set at position 0.
This is located at the rear of the freezer.
2. Adjust the thermostat control dial to the desired position,
bear in mind that the higher the number, the lower the
temperature. Position 4 is the recommended setting for
the freezer when operating at normal room temperature
(between 16°C and 32°C).
3. The freezer may not operate at the correct temperature if
it is in a particularly hot or a particularly cold room, or if
you open the freezer door often.
4. To ensure that the freezer is cool enough to sufficiently
chill your food wait 24 hours before filling it with food.
5. If you are concerned that your freezer is not being kept
cold enough and wish to check the temperature you will
need a special freezer thermometer. These are available
from most supermarkets and hardware shops.
6. Place the thermometer in the freezer, where it can be
read easily. Leave overnight, the temperature in the
freezer should be -18°C or lower.
Adjusting the Temperature
The internal temperature of your freezer is controlled by a thermostat. The recommended position
is between 1 to 4 for colder working environments (i.e. during winter) and between 5 to 6 for hotter
environments. Please adjusted according to the environment.
Fast Freezing
Fresh food should be frozen as quickly as possible. Setting position 7 makes your freezer operate the
coldest (approximately -28°C ) continuously. It helps to quickly freeze and retain more of the goodness
of your food. Freezing will be completed after 24 hours. Then turn the thermostat control dial back to
position 2-3 (-18°C). Never freeze large quantities of fresh food at one time.
Noises Inside the Freezer!
If you have not owned a freezer before, you may notice that it makes some rather unusual noises. Most of
these are perfectly normal, but you should be aware of them!
These noises are caused by the circulation of the refrigerant liquid in the cooling system. It has become
more pronounced since the introduction of CFC free gases. This is not a fault and will not affect the
performance of your freezer. This is the compressor motor working, as it pumps the refrigerant around the
system.
5
0
1
2
3
4
6
7
MUF50W10E_IB_5L_111025_ELable.indb 10
11年10月25日 下午6:41
