5
4-1 Power supply for preamplifier
This unit outputs ±5V 500mA and ±15V 200mA.
・Allowable range for use
Single wire : AWG26~16
Twisted wire : AWG24~16
・Standard stripping length
10mm
・Tool for operating the button Screwdriver(shaft diameter φ3, nose width 2.6)
4-2 Over current protection (O.C.P.)
This unit has incorporated an over current protection, and the output is to be cutoff when
the current reach to approx. 105% of maximum rated current.
When O.C.P is effective display shows “OVER CURRENT”.
Push the HV switch twice to reset.
4-3 Over Voltage Protection (O.V.P.)
This unit has incorporated an over voltage protection, and the output is to be cutoff when
the voltage reach to approx. 105% of maximum rated voltage even if any abnormality occurs.
When O.V.P is effective display shows “OVER VOLTAGE”.
Push the HV switch twice to reset.
4
Standard functions
4 Standard functions
-5V 0V 5V
-5V 0V 5V
-15V
15V
0V
-15V
15V
0V
Output connector for preamplifier power supply
Push the line inside while
pressing this part with a
screwdriver.
After taking the screwdriver
away, make sure that the line
does not come off by pulling it.
Summary of Contents for EP Series
Page 1: ...Rev 0 2 B N 035 9 114 035 9 114 MODEL EP series Instruction Manual ...
Page 19: ......
Page 20: ......