10 Troubleshooting for Digital Control
79
HARS series
10 Troubleshooting for Digital Control
10-1 Troubleshooting for Digital Control
If any problem occurred during digital communication, first check the following first.
No
Problem
Cause and treatment
1
Cannot communicate via LAN
If no communications at all
The LAN cable is not connected.
⇒
Connect the LAN cable.
2
Cannot communicate via USB
(CDC)
The USB cable is not connected.
⇒
Connect the USB cable.
3
A communication error occurs
during command transmission.
Excessive commands are transmitted.
⇒
Reduce the number of commands or increase the
interval between the command transmissions.
4
SCPI command does not work.
Remote mode is not set.
⇒
Send "SYST:REM" to set Remote mode.
(Refer to 7-3, 7-4, and 7-5-1.)
5
Web interface is not displayed.
Is the IP address of the network set to the default?
⇒
Set the network settings to the default. (Refer to 7-1-2.)
10-2 Inquiry
If the above does not improve the situation, please contact our sales representatives after preparing the
following items.
Name of your company
Department
Your name
Model and version
Connection status between remote operating equipment and the unit
(Which communication interface is used?)
Date of delivery
Problem
Frequency
Summary of Contents for HARS Series
