Single Phase EV Charger Protection unit
3 |
P a g e
Once installed, the unit has a Live Mains Supply (230v or higher)
within the enclosure. The cover must not be removed until the
supply to the unit has been isolated or disconnected.
Environment
matt
:
e
no longer use plastic bags as part of product packaging. Wherever possible we utilise reusable
biodegradable packaging for transportation. We ask that you support our efforts to reduce un-necessary
waste and recycle all packaging appropriately. Thank you.
Product Description
The
matt
:
e
Single Phase Electric Vehicle Charger Protection units are designed for use in domestic dwelling
applications where single phase PME supplies are feeding Electric Vehicle Chargers. They should NOT be
used on premises with 3 phase supplies
This manual covers the SP-EVCP-T(C), SP-EVCP-R(C), SP-EVCP-M(C), SP-EVCP-B(C), IP-EVCP-T(C), IP-EVCP-R(C),
& IP-EVCP-M(C) models manufactured after April 2020
The units are not intended for any purpose other than that defined within this document.
WARNINGS
Please read and observe the following notices carefully. These warnings must be observed when installing
and operating the Electric Vehicle Charger Protection units.
All relevant supplies must be isolated or disconnected before commencing any work. This
product must be installed by a competent person in accordance with the IET Wiring Regulations,
BS7671 (18
th
Edition or later) and any relevant Building Regulations and/or Installation
Regulations.
Safety Advice
The unit must be installed in a dry ventilated location; it must never be covered or have restricted
ventilation.
The SP-EVCP units are rated for a maximum 32A.
The SP-EVCP-R & IP-EVCP-R models are rated to be connected directly to the supply meter tails
via suitable connectors. All other models must be connected via the Consumer Distribution
Board or ‘Garage Board’ and suitable protective device
For any information not contained within this document, please contact our technical support team
on 01543 227290 or
info@matt-e.co.uk
.
