1.07
TI013G0008
Waste disposal should be performed in
compliance with the laws in force in the
country where the machine is installed.
Installation, setting up and use of
compressor should be carried out in
compliance with the standards and the
rules in force concerning safety at work.
The owner of the machine is responsible
for its good maintenance, an essential
condition to ensure safe operation.
Those machine parts that due to improper
use or wear do not ensure safe operation
should be quickly replaced.
Only trained, authorized and skilled
staff should perform the installation, use,
maintenance and repairs.
In case of difference between the
instructions given in this manual and
those foreseen by current laws concerning
safety, it is recommended to apply the more
restrictive ones.
Maintenance and repair
Only authorized personnel should carry
out maintenance, troubleshooting and
repairs.
Any maintenance and repair in progress
should be signalled by a speci
fi
c sign,
stating the maintenance condition and
placed on the control panel until completion
of the job, even if temporarily interrupted.
All operations for installation, maintenance
or replacement of components on the
machine or on the control unit should be
performed with the system switched off.
Therefore, the main switch should be on
OFF (OPEN) position and blocked with the
safety lock to prevent any movement to the
ON position.
Before acting, people in charge of
maintenance should
fi
rst check following
conditions:
General information
• that any receiver under pressure has
been exhausted.
Before working on pipes, receivers, hoses
and other components under pressure,
con
fi
rm that all internal pressure has been
relived from the system. Faulty components
must be replaced with others having the
same code. If during troubleshooting it is
necessary to carry out jobs with the control
unit and the machine live, all precautions
should be taken, as required by the safety
standards to operate under dangerous
voltages and with moving parts.
At the end of the maintenance and
troubleshooting jobs, all disconnected
safety devices should be reset.
Maintenance, repair and troubleshooting
should be ended by the checking of the
machine operation and of all its safety
devices.
Settings to be made by customer
Unless different contractual agreements
are taken, the following items are normally
at customer’s expense:
room preparation (including building
works, such as foundations or canali
zations, etc, if required);
anti-slip, levelled
fl
ooring;
layout drawing when preparing the site
and when installing the machine itself;
preparation of auxiliary services, sui
table for the system requirements (such
as electricity supply, pneumatic system,
etc);
preparation of the electrical equipment
conforming to 2006/95/EC Directive
adequate lighting complying with EN
60204-1 Standard;
