+
1.06
TI013G0008
Installation and commissioning
The installation and commissioning are
only permitted to authorized staff.
During installation, handle the machine
components as indicated in this manual; if
lifting is necessary, insure that equipment
used is properly rated for the load. Lift only
at locations indicated as lift points.
The machine installation should be as free
as possible from any material preventing or
limiting its view.
Remove any brackets or braces used to
protect the machine in transport.
Check that all the machine safety devices
are correctly installed and there are no
moving or loose parts.
Check for any visible damage.
Connect the machine pneumatic system
to the air distribution system and carefully
check that pressure is set to the correct
value.
Check consistency between the voltage
set on power transformers and the voltage
value of the electrical supply.
Before connecting the machine electrical
system, insure the main power supply is
disconnected and locked out. Verify that
accident preventing guards are correctly
installed and in perfect state.
The machine safety is not
guaranteed in case of removal,
by-pass or tampering of the
safety devices on the machine.
Operating the machine
Only authorized and trained staff should
operate the machine. The staff in charge of
operating the system should be aware that
the knowledge and application of safety
regulations is an integral part of their job.
Unskilled personnel should not access the
operating area and the machine control
panel when the system is ON.
Before starting the machine, carry out
following operations:
• C a r e f u l l y r e a d t h e t e c h n i c a l
documentation;
• Get information about the operation and
position of emergency stop devices on
the machine;
• Know which protections and safety
devices are
fi
tted on the machine, their
position and operation.
It is forbidden to either disconnect or partially
remove the protections and safety devices.
The same applies for danger signals located
in particular areas of the machine. It is strictly
forbidden to access the working area and the
control and power cabins during operation of
the equipment (even partial) or immediately
after it is switched off.
Protections and safety devices should be
kept in perfect state so as to allow correct
operation; in case of failure they should be
repaired or replaced.
The use of not authorized components and
accessories for the protections and safety
devices may lead to malfunctioning and
dangerous situations for the operating staff.
Decommissioning and dismantling
Only authorized staff are allowed to
decommission and remove the machine.
Before taking the machine out of operation
it is necessary to disconnect and lock out
the main power supply. Drain oils and
fl
uids,
remove all moving parts.
Disconnect the machine pneumatic
equipment from the air distribution system.
Remove the machine from the working
area following the instructions given in this
manual. Before lifting it, verify the correct
use of lifting devices and use only suitable
equipment
.
General information
