Mattel Hyper Scan Controller, Instructions Manual

Trouble Shooting

Problem:

There is not picture on your TV Screen.

Solution(s):

• Make sure the HyperScan

™

 Console, TV and  

  VCR/DVD Player (if used) are plugged into  

  power outlets. 

• Make sure that the DC Jack on the AC Adapter is  

  firmly plugged into the DC Input Connector on the  

  back of the console.

• Make sure the power switches on the  

  HyperScan

™

 Console, TV, and VCR/DVD Player  

  (if used) are on.

• Check the connections between the console and  

  the TV or VCR/DVD Player (if used) and review  

  the appropriate Setting Up Your System section  

  in this booklet to be sure the system is set up  

  correctly.

• Make sure all cable connectors are securely  

  plugged into the appropriate sockets.

• Make sure that the INPUT settings are correct  

  for your particular setup. (Review Setting Up Your  

  System, point 3)

• If you are using an RF Switch connection, make  

  sure that the Channel Switch and TV are set to the  

  same channel (3 or 4)

• Check to be sure that the Game Disc is placed  

  correctly into the console.

• Make sure that the Game Disc is clean and in  

  good condition. If dirty, wipe with a soft cloth  

  from the center to the outside.

SCAN BATTLE RESCAN

Problem:

There is no sound or sound quality if poor.

Solution(s):

• Check if the TV volume is turned off or muted. 

• Check the audio connections between the  

  HyperScan

™

 console and the TV or VCR/DVD  

  Player (if used) and review pages 5 and 6 to be  

  sure the system is set up correctly.

• Make sure the AV cable is plugged into the  

  “Input” connectors on the TV or VCR/DVD Player  

  (if used) and not the “Output” connectors.

• If you have a mono TV or VCR/DVD Player (if  

  used) and left one of the audio cables uncon 

  nected you may not get all game sounds. Use  

  a “Y” adapter to get both left and right sound  

  channels.

• If your TV or VCR/DVD Player (if used) has both  

  mono and stereo options, make sure it is set to  

  match your setup.

• Make sure that the input settings are correct for  

  your particular setup. (Review  page 5 point 3 on  

  input select information)

SCAN BATTLE RESCAN