INSTALLING BATTERIES
Use a screwdriver to remove the screw of the battery door.
Insert two AAA batteries noting the polarity. The (-) side goes on the spring.
Install the battery cover and secure with screw. Do not over tighten.
To keep your thermometer water-resistant, make sure the rubber gasket is lined up with the battery
compartment
Note:
“The default temperature reading for this thermometer is in °F. Press the °C/°F button inside of the
battery compartment to switch between temperature scales
Mounting the Thermometer on your grill cover
The stem diameter of this thermometer is .310”. The hole in your grill cover must be at least this
large in diameter. Remove the analog thermometer that is currently in the cover. Remove the wing
nut from the thermometer and carefully insert the threaded stem into the hole. Lift the cover
slowly so you can access the thermometer stem from inside the grill. Thread the wing nut back
onto the stem until finger tight making sure the thermometer LCD is horizontal.
USING THE THERMOMETER
Temperature Scale
Select the temperature reading in Fahrenheit or Celsius by pressing the C/F button inside the
battery compartment. The unit will be set in Fahrenheit as default temperature scale when the
batteries are inserted.
Getting started
#1. POWER ON/OFF, Backlight
Press once to turn on the thermometer and show Current Temperature
Pressing the power button while the unit is on will activate the backlight for 5 seconds
