Maverick MV150000, Instruction Manual

9

9

Driving

Driving an R/C car can be very difficult to master. We want you to have fun with your RC vehicle but please read 

the 

cautions detailed below followed by some basic tips to help you understand how to use your RC vehicle for the first 

time.
• 

Drive the vehicle in a very large space, especially until you get the feel of driving the vehicle.

• 

Do not drive on public streets or highways. This could cause serious accidents, personal injuries and/or property 

damage.

• 

Do not drive near members of the general public that could be placed at risk of injury.

• 

Do not drive in water or sand.

•  2.4Ghz radio frequency only functions in line of sight. If you drive behind a solid object or around a corner and 

lose sight of the vehicle you may lose control of the car.

If you hold full throttle on the transmitter, the vehicle will keep accelerating and run very fast. It is difficult to steer the 

vehicle running at high speeds. Drive the vehicle slowly by only pulling the throttle trigger a small amount to get used 

to how fast the car can go.
When the car is running towards the driver, the directions of the steering wheel are reversed.
Once you become conformable driving the vehicle, practice driving on a track with cones.
Keep practising until you feel comfortable with the steering, throttle and brake at low speeds.
Once you are feeling comfortable try the above using reverse.
When you have mastered the basics you will be able to drive at higher speeds in a more controlled fashion.
Allow the car to cool down for 15 minutes between each run

DISCONNECT THE BATTERY PACK 

AFTER USE!

Maintenance after driving

Proper maintenance is very important. Make sure to always perform appropriate maintenance after driving so that you 

can enjoy driving without problems next time.
Completely remove all dirt and debris from the vehicle, especially in the suspension, drive shafts and steering parts. 

Inspect each part and screws for loosening, missing parts or damages.
You should always make sure your wheels are tight and parts move freely after and before use.

Driving in wet conditions

This vehicle is designed to provide water protection for the on-board radio system components so it can be driven in 

wet conditions. The vehicle is not designed to be completely submerged in water. Driving in wet conditions will require 

additional maintenance.

Notes:

Never drive the vehicle in stormy conditions where lightning could be present. The transmitter is not waterproof,      

always keep it protected from rain and water.

Remove all water/mud and dry the vehicle completely after driving. Check the vehicle for trapped water in the tyres, 

transmission etc. Some metal parts like bearings and hinge pins will need lubrication after driving in wet or damp 

conditions. The electric motor is not designed to be submerged in water. If water gets inside it can reduce the life of 

the motor.

Most LiPo battery packs are not designed to operate in wet conditions. Consult the instruction manual or 

manufacturer for limitations.

After running in water, dry off any water from the ESC and connectors.