10
The ESC has a number of programmable modes that can be altered to suite a variety of functions. Each set of green
LED
fl
ashes/beeps represents the programmable mode (1
fl
ash = Running mode, 2
fl
ashes = Drag brake force and
3
fl
ahes = Auto-lipo settings etc..) and each set of red LED
fl
ashes/beeps represents that modes value. See the
table below for all the programmable modes and their values. When you enter the setup mode you need to keep the
button pressed until you enter the desired programme mode (green
fl
ashes/beeps). Once you reach that mode
release the button and that will allow you to change the mode value (red
fl
ashes/beeps). You need to switch off the
ESC to save the settings then re-do the process to change to a different mode or mode value setting. If you lose
your way with setup then you can return the unit to default settings by turning on the ESC, keeping the transmitter in
neutral and pressing the setup button for 3 seconds. Both red and green LED’s will
fl
ash together 3 times to con
fi
rm
this.
Changing the setup
LED
LED
While switching on the ESC hold down the setup button. Continue to hold the
setup button while the red LED
fl
ashes.
Continue to hold the setup button until the green LED starts to
fl
ash.
Red LED
fl
ashes for 4 seconds.
Green LED will begin to
fl
ash.
LED
LED
Each green LED
fl
ash represents the programmable mode number.
Release the setup button when you reach the desired mode. You are now in the program mode setting.
LED
LED
3 green LED
fl
ashes
represent the Low
Voltage Cut-Off setting
for example.
LED
Press the setup button to change the mode value. Each mode
value will have different amounts of red LED
fl
ashes.
In order to save the changes and settings
you must switch off the ESC. When you next
switch it back on it will have saved your new
settings. To make further alterations you
need to re-enter the mode values again.
1 red LED
fl
ash
represents the
“No Protection” setting
Program Modes
Running
Modes
FWD w/Brake
This mode is for forward and brake only
Fwd/Rev/Brake
This mode offers forward, brake and reverse. Note, The reverse uses a soft
start “Double Click” function which will only allow reverse to be activated once
the motor has stopped moving forwards.
Rock Crawler
This mode allows the reverse function to happen immediately. Drag Brake
should also be set to 100% to use this function for Rock Crawling.
Drag Brake Force
This allows the setting of an automatic drag brake when the throttle stick is
returned to neutral, simulating the slight braking effect of a brushed motor while
coasting.
Low Voltage Cut-Off
If the voltage of a LiPo battery pack is lower than the set threshold, the ESC
will cut off the output power by 50%. The ESC will completely cut off the output
power in 10 seconds.