7
Turning on the power
Turn on transmitter
fi
rst and then turn on receiver.
Turn on the transmitter switch and the LED battery
indicator will light up.
Turn on the receiver. The automatic set-up of the factory
set speed control should have been completed. If you
experience any problems with the speed control settings
refer to the Electronic Speed Control Section for correct
setup information.
The Red LED will show if the
installed AA batteries have
suf
fi
cient charge.
The Red LED will
fl
ash and
there will be an audible beep if
the batteries need replacing.
Power LED
You may need to setup your transmitter to ‘bind’ with the receiver if you change to a new receiver or for any reason
lose signal.
•
Place the transmitter and the receiver close to each other (within one meter).
•
Turn the power switch on the transmitter to the ON position.
•
Press and hold the receiver setup button, then turn the power switch to the ON position.
•
The receiver LED will
fl
ash quickly. Release the setup button after 1 second.
•
Press and hold the binding button on the transmitter for 1 second until the LED on the
receiver is continuously lit.
Binding the Transmitter and Receiver
Electronic Speed Control Setup
Turning off the power
Turn off receiver
fi
rst and then turn off transmitter.
If you switch off the transmitter
fi
rst before the R/C car, you may lose control of the R/C car.
•
Turn off the receiver switch.
•
Turn off the transmitter switch.
•
Disconnect the battery connector from the speed control connector.
MSC-29BL-80WP Features:
1. Water-resistant* and dust-proof. The ESC has been designed to
work in wet conditions.
a.*Please remove the cooling fan when using the ESC very wet conditions.
b.*After using the ESC in wet conditions, please clean and dry it to avoid
the oxidation to copper connectors
2. 2-3S Capalable (for 3S you must change the standard 5V
cooling fan to a 12V cooling fan, or supply the 5V cooling fan from
the receiver 5-6V);
3. Compatible with sensorless brushless motor.
4. 3 running modes (“Forward with brake” mode,
“Forward/Backward with brake” mode, and “Rock Crawler” mode).
5. Proportional ABS brake function with 4 steps of maximum brake
force adjustment, 8 steps of drag-brake force adjustment.
6. 9 Punch modes from “Soft” to “Very aggressive” to be suitable for different chassis, tires and tracks.
7. Multiple protection features: Low voltage cut-off protection for Lipo or NiMH battery / Over-heat protection /
Throttle signal loss protection / Motor blocked protection.
8. Easily programmed with the “SET” button on the ESC or with the LED Program Card.
