Seite 14 von 17
DOK-ID:UTX01G01 BE #5100063
3.
Installation and Use
3.1. User Environment
During the use of this product, the room temperature and humidity should remain in a range for
normal working and living conditions.
3.2. Installation, Connection methods, Connections
The MAVIG product/ system must be set up correctly in accordance with the assembly instruction
enclosed to the product/ system. Failure to follow the instruction can cause the system to be
unstable and/or mean that its function is reduced.
For following UT-Systems an installation manual is available:
UT System
Document
UT60-Series / UT6260 / UT6261
UKS11Oxx
3.3. Cleaning, Disinfection, Sterilization
3.3.1. Cleaning
For wiping all surfaces:
Use soft, particle-free and free of residues of other cleaning agents cloths for cleaning.
Only slightly moisten the cloth. If necessary, use a mild soap solution or commercial
washing-up liquid.
Make sure that no liquid is spilled during cleaning and penetrates the device.
Then rub dry the surfaces with a cloth.
CAUTION
Damage to the product
In oder to avoid damage to the product no aggressive, abrasive, caustic,
bleaching, akaline, acidic or corrosive agents should be used (e.g. solvents,
acetates, scouring agents, chlorine etc.).
3.3.2. Disinfection
Only use wipe disinfection.
No liquid may penetrate the product.
The applied reprocessing process must comply with the applicable legal regulations and
guidelines.
Hygiene procedures and conditions are the responsibility of the operator and must be
determined by him.
Ensure that the materials used are compatible (e.g. stainless steel, aluminum, plastic, lead
acrylic, lead glass, PVC, natural, silicone or synthetic rubber, chromed, painted or coated
surfaces).
In case of doubt, test the product suitability in an inconspicuous place.
