Page 79 P/N 03521015 Rev U1
Bio-Medical Devices Intl
17171 Daimler Street Irvine, CA 92614 800-443-3842 www.maxair-systems.com
Prepare Double Shroud and Helmet for Assembly:
WARNING
Dispose of contaminated Shrouds according to your Institution’s protocols.
Assembly
Disassembly
Reverse steps 3 through 9 to remove Shroud from Helmet.
1. Remove Shroud from packaging; note
Shroud is turned inside-out to mount to
Helmet.
NOTE
Read Sections 1 through 13 before proceeding.
3. Turn FCC front TurnClip
horizontal and attach
Shroud front Mounting Hole
over TurnClip. Turn TurnClip
vertically to secure the
attachment.
5. Snap one side of DLC onto one
side FFC Attachment Post; then
snap other side.
2. Grasp top of DLC Cuff and pull gently
away from Lens so that Cuff and
Flappers are away from Lens.
6. Hold helmet securely, grasp Shroud’s
rear Pull Tab and pull shroud up and
over helmet.
4. Pull Shroud top fabric up over the
front TurnClip and tuck it in under
and/or close to the FCC bottom
edge all around FCC.
7. Pull Shroud over and
down the back of the
Helmet.
8. Use Pull Tap to position Shroud
Rear Snap over FCC Rear Snap;
snap and secure.
9. Snap and secure left Rear Side Snaps between
Shroud and FCC. Then repeat on right Rear
Side Snaps.
