10
10
Building Your Double Trouble
13. Make up the rudder pull pull system by fitting a metal quick link on to the brass adaptor with a nut.
Put a metal ferrule on to the wire and then take the wire through the eyelet and then back through the
ferrule and loop it back through and tuck the end in to the ferrule and crimp the ferrule tight. Do this for
both sides but only at the rudder end for now.
14.
Thread the cables through the pre-ftted tubes in the fuselage to the servo bay and then fit the links
to the rudder. You may need to use a sharp knife to trim the film carefully around the openings for both the
rudder and elevator controls. Fit the elevator control rod as shown in the picture.
Summary of Contents for Double Trouble Balsa Pro-Built Series
Page 1: ...Instruction Manual ...
