13
13
Building Your Double Trouble
15.
Fit the upper wing supports using the M3 x 12mm Cap Head Screws.
16.
Turn the model over and sit it on the wing supports and fin, from here you can now fit the rudder
and elevator servos. If you are building the IC version you can now install the throttle servo and switch to
the non exhaust side of the model in the pre cut hole.
17.
Once the servos are installed you can finish of the rudder pull pull system by repeating the process
in the same way as before, make sure to pull them tight and try and get both sides the same length. The
elevator rod will need bending and cutting to suit your servo position and securing to the servo arm with a
swing keeper or you can make a z-bend.
Summary of Contents for Double Trouble Balsa Pro-Built Series
Page 1: ...Instruction Manual ...
