4
4
Building Your Double Trouble
1.
Start by glueing all of the hinges in place using CA Glue. Medium or Thick Slow set is best.
2.
Check for any wrinkles in the covering and using a film iron shrink these back so the film is tight.
3.
Install the control horns on to the Ailerons and also the upper and lower aileron connector plates.
You can trim down the plates to make sure they do not protrude through the covering if you wish and also
drill a small hole in the plate where it inserts in to the wing to give the 5 minute epoxy can grab through
the connector. These connectors go under the top wing and on top of the bottom wing. Servo horns go on
the under side of the bottom wing and under the elevator and are held in place with the M2 x 12mm self
tapping screws.
Summary of Contents for Double Trouble Balsa Pro-Built Series
Page 1: ...Instruction Manual ...
