3
UNPACKING INSTRUCTION
CAUTION!
Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damaged from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. If the product must be returned to the factory, it is important that the product is returned in the original factory box and
packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
Supplied contents:
-
MAX KB2 keyboard
-
Power supply
-
Music sheet stand
POWERSUPPLY
The label on the bottom of the product indicates to what type of power supply the product must be connected. Check that the
mains voltage corresponds to this, all other voltages may cause irreparable damage. The product must also be directly
connected to the mains, no dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONTROLS
1. SPEAKERS
Loudspeakers to reproduce the sound of the music played. sound level is determined on the basis of the volume setting.
2. POWER ON/OFF
Switch to turn the keyboard on or off.
3. MASTER VOLUME
Press [Master Vol +] or [Master Vol -] to raise or lower the master volume. Press both simultaneously to reset to default
value.
4. ACCOMP VOLUME
Press [Accomp Vol +] or [Accomp Vol -] to raise or lower the accomp volume. Press both simultaneously to reset to default
value.
5. TEMPO
Press [Tempo +] or [Tempo -] to increase or decrease the rhythm speed. Pressing the two buttons simultaneously may
reset to the default tempo.
6. SINGLE CHORD
When rhythm is activated, press [Single]. After
“SIN” shows on the display, you can play a single chord on the keys in the
chord zone of the keyboard.
Press [Single] again, “SIN” will disappear from the display. The single chord function will be
disenabled.
