12
DRIVING DEPTH ADJUSTMENT DIAL
ALWAYS disconnect air supply before adjustment dial.
q
With air pressure set, drive nails into a representative material sample to determine
if adjustment is necessary.
w
If adjustment is required, disconnect air supply.
e
Refer to the mark on the contact arm for direction to turn the adjustment dial.
r
Reconnect air supply.
DIRECTIONAL EXHAUST COVER
ALWAYS disconnect air supply before rotating the exhaust cover.
Direction of the exhaust air is changeable by rotating exhaust cover by hand.
TRIGGER LOCK MECHANISM
The tool is equipped with a trigger lock mechanism. Push and rotate the trigger LOCK
to the trigger UNLOCK position before driving nails.
HOW TO REMOVE PLASTIC SHEET
As nails are driven the plastic sheet will feed out of the tool. When sufficient strip has
been fed out it can be torn away by pulling against the tear edge in the nose.
HOW TO REPLACE THE HOLDER
ALWAYS disconnect air supply before attaching / detaching the holder.
To detach the holder, insert a screwdriver, etc. into its joint and squeeze.
When reattaching it, make sure that it has been securely fit in.
WARNING:
WARNING:
WARNING:
Adjustment dial
Deeper
Shallow
Driver
Holder
Deeper
Shallow
Trigger lock dial
Trigger
Summary of Contents for CN650M
Page 15: ...16...
