WHEN USING THE CONCRETE NAILS
This apparatus is exclusively designed for the concrete which was recently built. When
using it, conform to the Construction Standards, considering the conditions of members
and the situation at a construction site.
●
Choose the length of nails so that their penetration into the concrete will be 8 to 15 mm.
※
If penetration into the concrete is deeper than 15 mm or the concrete is hard, the nails
may not be fully driven.
Penetration into
concrete; 8 to 15 mm
Wood
Combination Example of Nails and Members
Wire Diameter
Nail Length
Member Thickness
Penetration into Concrete
27 mm
12 mm
Approx. 15 mm
32 mm
20 mm
Approx. 12 mm
38 mm
30 mm
Approx. 8 mm
45 mm
35 mm
Approx. 10 mm
2.5 mm
50 mm
40 mm
Approx. 10 mm
5.
MAINTAIN FOR PERFORMANCE
①
DO NOT FIRE THE NAILER WHEN IT IS EMPTY
②
USE RECOMMENDED OIL
The velocite or turbine oil should be used to lubricate the tool. Upon completion of operations, place 2 or 3
drops of oil into the air plug inlet with the jet oiler. (Recommended Oil : ISO VG32)
③
INSPECT AND MAINTAIN DAILY OR BEFORE OPERATION
Disconnect air supply and empty the magazine when inspecting or maintaining the tool.
(1) Drain air line filter and compressor
(2) Keep lubricator filled in air 3-pieces set
(3) Clean filter element of air 3-pieces set
(4) Tighten all screws
(5) Keep contact arm moving smoothly
6.
STORING
①
When not in use for an extended period, apply a thin coat of the lubricant to the steel parts to avoid rust.
②
Do not store the tool in a cold weather environment. Keep the tool in a warm area.
③
When not in use, the tool should be stored in a warm and dry place. Keep out of reach of children.
④
All quality tools will eventually require servicing or replacement of parts because of wear from the normal
use.
7.
TROUBLE SHOOTING/REPAIRS
The troubleshooting and/or repairs shall be carried out only by the MAX CO., LTD.authorised distributors
or by other specialists.
15
Summary of Contents for HN50
Page 16: ...16...
