52
A home point is usually memorized by the system as the point
where the aircraft motors start up each time. The home point can
also be repositioned during flight.
¾
Reposition the home point during flight
1.
Maneuver the aircraft to the desired home point.
2.
Release the command sticks when the aircraft reaches
the target position to let it hover.
3.
Press and hold the Take-off Button for 3 seconds until a
beep sound is heard.
4.
Press the Take-off Button again within a 5-second
interval; hold the button until a beep sound is heard.
The rear LEDs of the aircraft will show quick flashing
green lights for 3 seconds indicating the reset is
successful.
z
Failsafe
The Failsafe function will be activated after 5 seconds when
communication between the aircraft and the remote controller is
lost. This function enables the aircraft to automatically take the
protection measure.
Go Home is set as the priority protection measure when Failsafe is
activated.
In the case when GPS is available at the time Failsafe is activated,
the aircraft will start the Go Home procedure automatically.
In the case when GPS is not available (i.e. received GPS satellite
signals are less than 6) when Failsafe is activated, the aircraft will
hover for a 10 seconds interval. If GPS becomes available during
this interval, the aircraft will start the Go Home procedure,
otherwise the aircraft will land onsite.
