74
z
Failsafe
The Failsafe mode is set to enable the aircraft to take default
emergency protection procedure when communication with
the remote controller is lost, to prevent damage or injury. Go
Home is set as the priority protection measure when Failsafe
is activated.
When the Go Home procedure initiates, the aircraft’s nose
will be oriented towards Home Point. If the aircraft’s altitude
is lower than 30 meters, it will ascend to 30 meters height to
reduce risks of crashing or damages. If the aircraft altitude is
higher than 30 meters, then the aircraft will remain at its
height level, and returns to the home point with the shortest
flight route.
To view the demonstrations of the Failsafe procedure, tap the
Failsafe icon and the screen as shown below will be
displayed.
Figure 4-20
Failsafe Screen
There are several occasions that may cause the loss of the
remote controller signal:
A. The controller has been turned off
B. The aircraft has flown out of the distance limit
C. The signal between the aircraft and the remote controller
has been blocked or interfered
