P/N 01023649 Rev B Page 3
DLC Cuffs
(Disposable Lens Cuffs)
User Instructions
WARNING
If conditions 1 and 2 both are not achieved, switch to the other size DLC and repeat Donning steps 1 through 6 above.
Condition 1:
Ensure the DLC Flappers are
away from the Lens, positioned perpendicular to
your temples, and in front of the FCC Side Tabs.
DLC Flappers
FCC Side Tabs
1. Place the Belt top edge under the Battery Clip, with the Belt
fully under and up to the Clip top. Place the belt around the
waist with the battery near the side-back of the right hip.
Donning
2. Connect the Helmet Power Cord to the Battery. Push
the Power Cord Connector into the Battery Receptacle
until the Secure Connection audibly clicks.
6. Slide your fingers between Cuff
and face from temples down
under the chin to pull the DLC
Flappers away from the lens,
and properly position the cuff.
4. Hold the Helmet at the rear
headband, pull the DLC Cuff
down, place your chin into the
DLC Cuff. Pull the Helmet over
and down on your head.
3. Loosen the rear
Headband Adjustment
Knob by turning it
counterclockwise.
5. Tighten the rear
Headband Adjustment
Knob (clockwise). Ensure
a tight but comfortable fit
for all activities.
4. The DLC Front Alignment Hole secured,
grasp one DLC end by the Flapper and
stretch it tauntly until that side Mounting
Hole is over that side Mounting Post.
5. That side DLC Mounting Hole centered over the FCC side
Mounting Post, press the DLC down fully onto the Mounting
Post. An audible click indicates the DLC is properly around
and down securely on the Mounting Post.
6. Repeat steps
4. and 5. for
the other side.
Condition 2:
Ensure slight tension on the cuff is felt continuously while
sliding the index or first finger between the cuff and the face all along
the chin and up to the temples, from the right side of the face to the left.
Assembly Steps 4-6 Option B
