P/N 01023649 Rev B Page 4
DLC Cuffs
(Disposable Lens Cuffs)
User Instructions
WARNING
Refer to Section 9, User
Instruction Manual P/N
03521015, for details on
proper use of chargers
and for charging
batteries.
4. Disconnect the Battery Belt
from around the waist by un-
snapping the buckle.
5. With the Charger connected to the mains wall power,
push the Charger Cord Connector into the Battery
Receptacle until it is fully seated.
2. Grasp both side DLC Flappers and
lift out and away from the FCC Side
Attachment Posts.
3. Continue to pull the DLC forward off the front
TurnClip and away from Helmet.
Dispose of the DLC according to your
institution’s protocol for contaminated waste.
Disassembly
1. Align FCC front TurnClip
horizontally.
Doffing
1. Loosen the rear Headband
Adjustment Knob (turn
counterclockwise).
2. Pull the DLC Cuff away from
the chin and lift the Helmet up,
forward, and off the head.
3. Disconnect Battery from the Helmet -
push Secure Connection Button down,
pull Cord Connector out, release Button.
CAUTION
If the Helmet is not secure and comfortable, it may be necessary to change the Height Adjustment,
which raises and lowers the rear headband and the Helmet angle with respect to the head, and
properly positions the DLC Lens from the chin. Together with the Adjustmont Knob they optimize a
secure and comfortable fit and proper positioning for easy visualization of the LED Safety Status
Indicators. To adjust, unsnap the Height Adjustment tabs on each side of the Helmet Liner and
reposition upward or downward. .
Be sure to have both Height Adjustment tabs in the same position.
≤ 1/2
Inch
(~1.25 cm)
CAUTION
Optimum setting is achieved
when the helmet is secure on the
head for all movements required
and the front headband is within
1/2 inch of the eyebrows to allow
good visualization of the LED
Safety Status Indicators in the
upper peripheral vision.
7. Position the Helmet so that the front headband is within ½ inch of the eyebrows and
the rear headband is resting under the occipital bone above the vertebrae on the
neck, and then tighten the Adjustment Knob clockwise to ensure the most secure fit
of the helmet on the head for all activities. Do not over tighten to cause discomfort.
