MENUS: 1Y.5 HARDWARE
7 - 14
D-MAXE with OI-TS
www.maxcessintl.com
MI 2-292 1 C
Men
üs
.fm
1y.5.1.1.5 Current Range
The
Current Range
menu shows in which range the sensor input
on the D-MAXE controller was configured according to the last
valid sensor calibration.
1y.5.1.5 Line Speed The
Line Speed
menu is used to calibrate the analog Line Speed
signal. This signal can be used for example to influence the
guiding sensitivity of the drive (see menu
)..
1. The reference value for the minimum web speed must be
determined.
To do this, the material web with the relevant application
must be running at minimum web speed in the customer
system.
2. The reference value for the maximum web speed must be
determined.
To do this, the material web with the relevant application
must be running at maximum web speed in the customer
system.
3. If the result determined from the reference values for web
speed-dependent guiding can be used, the display shows
"Successful!".
Note:
If the result for guiding is too low, an error appears in the menu
and the calibration must be repeated.
1y.5.1.7 Encoder
...
1y.5.1.8 Motor Encoder An incremental position transducer (encoder/motor encoder)
can be connected to each drive on the D-MAXE to record
positions. This makes position monitoring and evaluation
possible.
In most applications, the encoder is used together with a sensor
positioning system.
2
1
3
